How to Break in Work Boots Like a Pro

After purchasing a fresh pair of work boots, there’s a high probability that they’ll be the perfect fit right out of the box. Upon trying them on, a few pinches and aches are common, typically around the heel sections and the sides of the toes.

 

Before you begin to wear them for an extended period, at first, it is required that you break them in. However, not doing so might cause your feet to experience extremely rough weeks of pain.

 

Want to know how to break in your new work boots like a PRO? We’ll show you how. If it’s done properly, the stiffness and blisters of your work boots will be a thing of the past.

 

Here Are a Few Ways to Break in New Boots Without Spending a Lot of Money Doing So

 

1. The Oily Treatment: Make use of a leather conditioner such as Mink oil to adequately coat the external sections of the boots where there are pinches. Allow them to sit overnight and use a cloth to wipe off the excess in the morning. The oil aids in softening the leather in the concentrated area, which results in the boots being more comfortable.

 

2. The Hot Water Treatment: Military personnel utilizes this method. Obtain a bucket and pour some warm water in it. Submerge the new work boots in the warm water and allow them to sit there for about a half of an hour (if finished leather is used to construct the boots, allow more time). When the boots become saturated, flip the boots with the collar facing down and allow the excess water to drain out then wear with socks for a next 30 minutes to an hour.

 

Please note: Before you carry out this procedure, ensure that you carefully read the waterproofing guide that we provided.

 

3. The Cold Water Treatment: Obtain a Ziploc bag and pour some cold water into it. Ensure that you release the excess air from the bag before you seal it. Put the bag into the work boots while making certain that the water is pointing towards the boots’ pinch. Place the boots in the freezer and allow it to stay overnight.

 

The boots will be stretched when ice is formed when the water freezes. Afterward, take the boots from the freezer and allow the ice to fully melt before removing the bag.

 

4. The Stick Treatment: Use a mop or broomstick and insert it into the work boot while focusing the stick in the direction of the heel or toe area where there is tightness. Afterward, lightly but securely angle the boot over the stick in order to allow the leather to stretch out of the sole in the impacted region. You will notice that the leather will be partially discolored outwards which depicts that the boot has been stretched.

 

In terms of breaking in boots, you have no other choice but to wear them. Besides, immediately attempting to wear new unbroken boots may take around 3 to 6 weeks before they can properly fit your feet comfortably. Throughout that period, you’ll be receptive to corns and blisters. However, if you follow the above tricks, your boots can give an excellent fit in just days.

 

BONUS HELPFUL TIPS

 

Prior to breaking in your boots, you should consider these things:

 

  1. Even before starting your break-in procedure, purchase work boots that fairly fit your feet well. – Try to obtain some extremely comfortable work boots.
  2. Desist from purchasing new work boots a day or two before they’re needed. – This is a factor of the time it takes to break in. (It’s totally dependent on the boot. However, it generally takes about 2 weeks.)

 

  1. Gradually breaking in and over increasing the extended periods are more suitable than conducting a breaking in session of 10 to 15 hours.

 

  1. If you’re experiencing issues with your feet, stay away from breaking them in. – painful corns, blisters, plantar fasciitis, extensively long nails, toe nails that are in-grown etc.